Peripherals] Window - Furuno FMD-3200-BB Instruction Manual

1. INITIAL SETTING AND ADJUSTMENT
4. For the Chart Radar, select the Equipment ID of the radar processor unit from
the [Equipment ID] pull-down list. Setting range: [RAS001] to [RAS004]. Do not
use [RAS005] to [RAS010]. For the ECDIS, go to step 8.
The [Equipment Name], [Equipment Type No.], and [IP Address] are automatically
entered according to the Equipment ID.
5. Select [RPU-013] from the [Equipment Type No.] pull-down list.
6. Select the antenna position from the [Antenna Position] pull-down list.
Settings: [Fore], [Main Top], [Main 2nd], [Main 3rd], [Aft], [Port], [Starboard].
7. Click the box of [Serial No.] to enter the serial number of the radar processor unit
(example: xxxx-xxxx).
8. Click [Save] on the info bar. Several confirmation messages appear. Click [OK] to
reboot the system. To discard all changes, click [Discard Changes].
1.2.2

[Peripherals] window

1. Access the [Common Installation Setting] menu and click [Basic Setting] on the
tab bar.
2. Click [Peripherals] on the menu bar.
1
* Not used.
* 2 Shown for the ECDIS.
* 3 Shown when [Connected] is selected in [Connection] of [Service Gateway].
3. Select the monitor type and resolution connected to the DVI1 port from the [Type
Number] pull-down list of DVI1.
The setting options are as follows:
• [MU-190 (SXGA)]
• [MU-231 (SXGA)]
• [MU-231 (UXGA)]
• [MU-270W (WUXGA)]*
• [MU-270W-B (WUXGA)]*
• [MU-201CE (SXGA)]
• [MU-231CE (SXGA)]
• [MU-231CE (UXGA)]*
• [JH 19T14FUD (SXGA)]
1-6
*1 *1
*2 *2
1
1
3
• [HD 24T22FUD (WUXGA)]
• [HD 26T21MMD (WUXGA)]
• [HD 26T22MMD (WUXGA)]*
• [HD 26T22FUD (WUXGA)]
• [HD 27T22FUD (FHD)]*
• [HD 27T22FUD (WUXGA)]
• [HD 32T22FUD (FHD)]*
• [HD 32T22FUD (WUXGA)]
• [HD 55T22FUD (FHD)]*
*3
2
4
4
4