Initial Settings; How To Select Language And Units, Open The Installation Menu Window - Furuno NAVpilot 711C Operator's Manual

7.

INITIAL SETTINGS

This chapter shows you how to enter initial settings, on the [Installation Menu] window.
The menu contains some items that may not apply to your system. Minimally, the set-
tings on the following menus must be done:
• [Ship's Characteristics] menu
• [Dockside Setup] menu
Note: The [Dockside Setup] menu is not shown when [Boat Type] is set to [EVCS
Boat].
7.1 How to Select Language and Units, Open the In-
stallation Menu Window
1. Press the
The first time the system is powered, the language selection window appears.
2. Rotate the Course control knob to select a language then push the knob.
3. Press the
The units on the [Units Setup] menu are set according to the language selected.
4. If you want to change the units, do as follows. If not, go to the next step.
1) Rotate the Course control knob to select the current setting to change then
push the knob.
2) Rotate the Course control knob to select a unit then push the knob.
key to turn on the power.
key to open the [Units Setup] menu.
Units Setup
Speed Unit: kn
Range Unit: NM
Wind Speed Unit: kn
Depth Unit: ft
Water Temp Unit: °F
Prev Next
7-1