Furuno FMD-3200-BB Instruction Manual page 55

10. Click the [Save] button. According to the data that you entered, the information of
the sensor information box is updated.
Example: Sensor information box
Note: For the heading data, use the data input from the heading sensor.
11. Monitor the route that the vessel is in the channel limit.
12. According to the autopilot connected with the ECDIS, do the following procedure.
For FAP-3000, PR-6000 or PR-9000
Click the [TCS], [TCS Setting] button and se-
lect [Go AW] or [Go SEA] on the InstantAc-
™
cess bar .
For PT-900 or NP-5400
Click the [TCS], [OP] button and select [Go
AW] or [Go SEA] on the InstantAccess
™
bar .
For FAP-2000 or PT-500A
At the autopilot, push the Go AW or Go SEA button as appropriate.
13. Change the steering mode of the autopilot to NAV mode.
14. Confirm that [Go AW] or [Go SEA] appears at the [TC] column of the route infor-
mation box.
• [Go AW] or [Go SEA] appears:
The connection between the
ECDIS and autopilot is correct.
• [Go AW] or [Go SEA] does not
appear: Check the configuration
and connection between the
ECDIS and autopilot.
1. INITIAL SETTING AND ADJUSTMENT
TCS
TCS
TCS
Setting State
Go
AW
Go
SEA
TCS
TCS OP
Status
Go
AW
Go
SEA
XTD Limit:
XTD:
2.20 NM
1.00 NM
Example: Route information box
Select [Go AW] or Select [Go AW] or
[Go SEA]. [Go SEA].
Select [Go AW] or Select [Go AW] or
[Go SEA]. [Go SEA].
Confirm that [Go Confirm that [Go
AW] or [Go SEA] AW] or [Go SEA]
appears. appears.
1-49