Factory Test & Default] Menu - Furuno FMD-3200-BB Instruction Manual

1.13 [Factory Test & Default] Menu
The [Factory Test & Default] menu does the factory test to check operation and re-
stores the system default settings.
Factory Test
Click [Start] to perform the factory test. The result of the test is shown on the display.
If "NG" appears, confirm the state of the unit on the [System Monitor] menu.
Factory Default
The factory default function restores all factory defaults (except the settings on the
[Basic Setting] menu). In the default arrangement all processor units powered in the
network are restored to default condition. To restore only the settings of the processor
unit, disconnect the LAN connector from the LAN1 port of the processor unit before
restoring the factory defaults.
Note: The route and user chart data are not deleted when the factory default function
is performed on the [Factory Test & Default] menu.
1. Click [Reset to Factory Default]. The following message appears on the screen.
2. Click [OK] to restore the system to the default setting.
The progress bar shows update progress. When the restoration is completed, the
system is automatically rebooted.
3. If connected to the gateway network, the link is shown on the display after com-
pleting the system reboot. Click the link on the display to access the [Common In-
stallation Setting] menu.
If connected to the sensor network, enter the IP address of the sensor network
to access the [Common Installation Setting] menu after completing the system re-
boot.
1. INITIAL SETTING AND ADJUSTMENT
The result of the test is shown in this area.
1-73