Furuno FMD-3200-BB Instruction Manual page 52

1. INITIAL SETTING AND ADJUSTMENT
6. When [FWD DIST NM] is different between port and starboard sides, check the
checkbox of [Use different values for Port and Starboard] and then enter each set-
ting value.
7. Confirm the TCS is stopped and click [Save] to save the Navigation Parameter.
Note: When you click [Save] while the TCS is activated, the TCS is force-quitted.
[Service State] button
When the TCS is activated in the service mode, the [Service State] button is enabled
on the [Navigation Parameter] setting window. The gain value is changed to minimum
value and the XTE correction is invalid when you click the [Service State] button. Use
the [Service State] button to adjust [FWD DIST NM].
Note: Use the [Service State] button while the ship is turning. The vessel may go off
the route because the XTE correction is invalid.
1. Enter the value comparable to the ship's length to [FWD DIST NM] on the [Navi-
gation Parameter] setting window.
2. Activate the TCS and monitor any route.
3. When the vessel comes up to WOL, click the [Service State] button.
1-46
[Service State] button