Furuno FMD-3200-BB Instruction Manual page 27

Item
[Output] Sets the output sentence formats from the se-
rial port.
• [Output sentence whose destination corre-
sponds with this sensor.]: Check the check-
box to activate any of the following items.
• To output the ACK and HBT sentences in
response to the ALR sentence from the
external sensor.
• To output the ACN and HBT sentences in
response to the ALF sentence from the
external sensor.
• [Data Source]: Select the serial source from the pull-down list.
• [Formatter]: Input the formatter for serial output. Up to eight sentences can
be input for one source. For example, input "HDT,ROT" to set the HDT
and ROT sentences.
• [Thin Out]: Check the checkbox to output with a lower transmission rate
when forwarding data.
Note 1: The ECDIS and Chart Radar can send NAV STATUS (ship's condi-
tion) and messages to an AIS transponder. Output the sentences VSD,
ABM, AIQ and BBM, when an AIS transponder is connected.
Note 2: Output the CRQ sentence to show the NAVTEX receiver mask in-
formation. For details about the NAVTEX receiver mask information, see the
operator's manual.
Note 3: When the following setting is entered, the ECDIS or Chart Radar
outputs the EVE sentence. In this case, the maximum transmission cycle is
one second.
• [Data Source]: ECD***/ALERT or CRA***/ALERT
• [Formatter]: EVE
***: Changed according to the equipment ID.
[Filter] Activates or deactivates the input sentence filter.
Check the checkbox to use only the specified sen-
tences. For example, to use the HDT sentence
when the HDT and ROT sentences are received,
check the checkbox and enter "HDT" in the [Filter]
column.
Note: If it is not possible to input limit to the Talker,
enter ** (wild card), before sentence name. For ex-
ample, "**HDT".
7. Click [Digital Input] of [No.1 ECDIS] or [No.1 Chart Radar] on the menu bar.
The pin no. of J11 on the I/O board of the processor unit and the corresponding
input/output channel no. are shown below.
Pin No.
5, 6
7, 8
9, 10
11, 12
15, 16 or 14, 15
Direction Channel No.
Output Channel 01
Output Channel 02
Output Channel 03
Output Channel 04
Input Channel 01
1. INITIAL SETTING AND ADJUSTMENT
Remarks
Contact Status
Normal Close
Normal Close
Normal Open
Normal Open
Depended on the configuration.
1-21