Furuno FMD-3200-BB Instruction Manual page 92

1. INITIAL SETTING AND ADJUSTMENT
[Dial Title]: Enter the title to show at the top of [Dial Meter 1 (or 2)] indicator.
[Primary Source]: Select the data source of the long pointer of [Dial Meter 1 (or 2)]
indicator.
[Secondary Source]: Select the data source of the outer pointer of [Dial Meter 1 (or
2)] indicator.
[Peak Source]: Select the data source of the short pointer of [Dial Meter 1 (or 2)]
indicator.
[Unit]: Set the unit of the data.
[Start Value]: Set the minimum value of the [Dial Meter 1 (or 2)] indicator.
[End Value]: Set the maximum value of the [Dial Meter 1 (or 2)] indicator.
[Angle]: Define the extent of the dial.
[Rotation]: It can be rotate the direction of the [Dial Meter 1 (or 2)] indicator. Normal-
ly, set to "0".
[Scale Resolution]: Select the scale resolution of [Dial Meter 1 (or 2)] indicator.
[Decimal Place]: Check the checkbox to show the value after decimal point.
[Mathematical Sign]: Check the checkbox to show the minus sign (-) when the value
is a negative figure.
• Generator Engine
[Title]: Enter the title of the component.
[Label]: Enter the data name.
[Actual Source]: Select the data source of the actual engine generating power.
[Rated Source]: Select the data source of the rated engine generating power.
• Generator Engine Bar
[Title]: Enter the title of the component.
[Number of Show]: Set the number of graphs.
[Label]: Enter the text on the upper of the graphs ([Object 1] to [Object 9]).
[Source]: Enter the source of the graphs ([Object 1] to [Object 9]).
1-86