Activating The Connection With The Processor Unit Of The Far-28 Series Radar (Ecdis Only) - Furuno FMD-3200-BB Instruction Manual

1. INITIAL SETTING AND ADJUSTMENT
Item
[Details]
13. Repeat the procedures from step 4 to enter the settings to another processor unit.
14. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
1.4.3 Activating the connection with the processor unit of the FAR-
28 series radar (ECDIS only)
1. Click [Radar] on the menu bar.
2. Check the check box for each FAR-2xx8 series radar processor unit to be con-
nected. Setting range: [RAD111] to [RAD118]
The Equipment ID checked on this step is shown on the menu bar.
Note: Do not use [RAD001] to [RAD010].
1-24
• [Name]: Enter the appropriate sensor
name.
• [Data Type]: Set the contact output.
[Normally Open] is for [Channel 01] to
[Channel 02], [Normally Closed] is for
[Channel 03] to [Channel 04].
Note: [Data Type] is not shown for the
Sensor Adapter setting.
• [Output Time (100msec)]: Set the out-
put time (recommended value: 10).
• [Dead Band (100msec)]: Set the dead
band after output (recommended value: 5).
• [Calibration Active]: Keep the default setting. (Default: without check)
• [Active Status (1)], [Active Status (0)]: Keep the default setting.
RAD001 through RAD010 are not used.
Remarks