Furuno FMD-3200-BB Instruction Manual page 31

3. Click the [Details] button to set the following items, referring to the table shown be-
low.
Item
[Equipment Name]
[Equipment Type
No.]
[SFID]
[System Alert ID]
[Alert Information
Source]
[ALF Text Informa-
tion]
[Sensor Network]
[Gateway Network]
[Radar Sensor]
4. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
Enter the name of the equipment.
Shows the equipment type number.
Keep the default settings.
The identification number that is assigned in the system is shown
in this field. Do not change the setting.
Set the source of alert definition to show on the display when the
alert message is received in an ALF sentence.
• [Alert Definition]: Show the alert definition registered to the pro-
cessor unit.
• [Alert Sentence]: Show the alert definition included in the ALF
sentence.
Note: Be sure to set [Alert Sentence]. An FAR-28 alert will not
be displayed in the AMS mode unless [Alert Sentence] is set.
Select the type of the 2/2 packet text information of ALF sentence.
• [All Alert Name]: Select this item if all alert text is included in the
2/2 packet of the ALF sentence. The text information on the 2/
2 packet of the ALF sentence is shown as the alert name in the
alert list/log.
• [Remaining Alert Name]: Select this item if the alert text is di-
vided in 1/2 and 2/2 packets of the ALF sentence. The text in-
formation for both the 1/2 and 2/2 packets of the ALF sentence
is shown as the alert name in the alert list/log.
• [Decision Support]: Select this item if the alert details informa-
tion (Decision Support) is included in the 2/2 packet of the ALF
sentence. The text information for the 2/2 packet of the ALF
sentence is shown as the alert details in the alert list/log.
Shows the IP address of the sensor network. Do not change the
setting.
Shows the IP address of the gateway network. Do not change the
setting.
Select the Equipment ID of the antenna unit connected with the
processor unit.
1. INITIAL SETTING AND ADJUSTMENT
Remarks
1-25