KidKraft NEWPORT PLAYSET F29015 Installation And Operating Instructions Manual page 20

Step 6: Swing Wall Assembly
Part 2
C: Place (1861) SW Mount across (1924) SW Floor and (1925) SW Top and attach using 2 (G4) 5/16 x 4" Hex
Bolts (with lock washer, flat washer and t-nut) as shown in fig. 6.2. Notice the side hole locations are towards the
top of the board.
Note: Pre-drill all holes using a 1/8" drill bit before installing the lag screws.
D: Make sure assembly is square then fasten (1924) SW Floor to (1500) Posts in the top holes using 2 (LS1)
1/4 x 1-1/2" Lag Screws (with flat washer); and (0369) Lower Diagonal to (1500) Post with 1 (LS3) 1/4 x 3" Lag
Screw (with flat washer). (fig. 6.2)
E: Tighten all bolts.
Fig. 6.2
Notice the hole
locations
Wood Parts
1 x SW Mount 2 x 4 x 38-1/8"
1861
5/16"
T-Nut
1861
1924
1500
1/4" Flat
Washer
LS3
2 x G4
2 x
LS1
1 x
LS3
LS1
Step 6 Part 2
Hardware
5/16 x 4" Hex Bolts (5/16" lock washer, 5/16" flat washer and 5/16" t-nut)
1/4" x 1-1/2" Lag Screws (1/4" flat washer)
1/4" x 3" Lag Screws (1/4" flat washer)
20
1925
5/16" Flat
Washer
5/16" Lock
Washer
G4
1/4" Flat
Washer
LS1
G4
europecustomerservice@kidkraft.com