0Xa5] Eas Alarm - Feig Electronic OBID i-scan ID ISC.PR101 Manual

®
OBID i-scan

8.3.4. [0xA5] EAS Alarm

If the EAS bit is set to 1 the EAS response status 0x00 is returned from the transponder. This com-
mand is available in all modes (non-addressed , addressed and selected).Whether the reader receives
the sequence or not is shown to the host by setting the status byte.
REQUEST-DATA
5
0xA5 MODE
RESPONSE-DATA (STATUS = {0x95})
5
ISO-ERROR
MODE:
Bit:
Function
ADR:
UID:
Read-only serial number of the transponder. The UID is required only in the addressed mode.
ISO-ERROR:
ISO error code of transponder response. This byte is only available if STATUS = {0x95}.
Note:
• If an error is detected or the EAS bit is set to "0" the transponder remains silent and the
status 0x01 will be sent to the host.
• If EAS bit is set to "1" the status will be 0x00.
FEIG ELECTRONIC GmbH
System-Manual
6 (7-14)
UID
7 6
- -
ADR
b000 non-addressed
b001 addressed
b010 selected
5 4
- -
Page 92 of 131
ID ISC.MR/PR/PRH101
3 2 1
- ADR
H60301-3e-ID-B.doc
0