Cfg6: Scan-Mode1 - Feig Electronic OBID i-scan ID ISC.PR101 Manual

®
OBID i-scan

3.7. CFG6: Scan-Mode1

The parameters of the CFG6 configuration block contain Scan-Mode settings. To enable Scan-Mode
the SCAN-MODE bit in the configuration block CFG1
Byte 0
Contents SCANNER-
MODE
Default 0x02
MR101
Default 0x80
PRH101
Byte 7
Contents SCAN-LOCK-
TIME
Default 0x0A
MR101 1 sec.
Default 0x0A
PRH101 1 sec.
SCANNER-MODE
defines the mode of the scanner.
Bit:
Function
mode:
b000:
b010:
Trigger:
b0:
b1:
FEIG ELECTRONIC GmbH
1 2
0x00 0x00
8 9
0x00 0x00
7 6 5
Trigger 0 0
Single Read: (active for read duration – stops after good read)
When all Transponders in detection range has been decoded, the Reader
will stop the scan. The Reader must be triggered again to read other Trans-
ponders.
Continuos Read:
The Reader will read as much Transponders as it can decode regardless
whether it is the same or not. This mode is mainly used for demonstration
and diagnostic.
Trigger disabled:
The Reader scans all the time. However, this mode increase the current
consumption
Trigger enabled: (only ID ISCPRH101)
The Reader start the scan, if the trigger is activated by the external switch.
Note
If Trigger is enabled an not activated by the external switch, the RF-
field will be switched off.
System-Manual
(3.2. CFG1:
3
SCAN-DATA
0x01
0x01
10
0x00 DB-ADR
4 3
0 0
Page 32 of 131
ID ISC.MR/PR/PRH101
Interface) must be set.
4 5
0x00 0x00
11 12
D-LGT
0x05 0x04
0x05 0x04
2 1 0
mode
H60301-3e-ID-B.doc
6
SCAN-LOCK-
TIME
0x00
0x00
13
D-START
0x00
0x00