Feig Electronic OBID i-scan ID ISC.PR101 Manual page 35

®
OBID i-scan
D-START:
This parameter defines the first byte in the raw data (defined by DB-ADR and D-LGT), which
will be transferred in Scan-Mode. To transfer the whole data block D-START must be set to 0.
Note:
The size of one data block depends on the type of Transponder.
The maximum number of the transferred data bytes depends on the reader type and configuration
settings and the used sign type.
without serial
number
RS232/
128 signs
485
40 signs
USB
40 special char.
* Only characters from A to X and 0 to 9 are non special character.
Note:
If an USB-Reader is used in Scan mode and "ASCII formatted hex-data" is configured it will be
distinguish between letters, numbers and special character(symbols). The special characters
will be first changed into the Unicode than into the USB-Keycode. Therefore you can transfer
more letters and numbers than special characters.
FEIG ELECTRONIC GmbH
System-Manual
hex-formatted
with serial with 1 separation
number character
128 signs 128 signs
32 signs 32 signs
32 special char. 32 special char.
Page 35 of 131
ID ISC.MR/PR/PRH101
ASCII formatted
without serial with serial
number number
80 signs 72 signs
80 signs 64 signs
53 special char. 43 special char.
with 1 separation
character
71 signs
63 signs
42 special char.
H60301-3e-ID-B.doc