0Xa1] Write Config Block - Feig Electronic OBID i-scan ID ISC.PR101 Manual

®
OBID i-scan

6.1.15. [0xA1] Write Config Block

This command writes one config block of the i-scan memory model (see
Code 1 Transponders).
REQUEST-DATA
4
0xA1 MODE
MODE:
Bit:
Function
ADR:
b001
UID:
Read-only serial number of the Transponder.
CB-ADR:
Address of the config block to be read from the Transponder.
CB:
Config block to be written to the Transponder.
Note:
• This command is only available for I-Code 1 Transponders.
• The command is not available if the Reader is set to original I-Code Memory Model.
(see 3.5. CFG4: Transponder
To write the Config Block 0,1,2 can now be done with Write Multiple Blocks [0x24] on the
original I-Code Address 2,3,4.
When using ISO15693 Transponders the command
be used.
FEIG ELECTRONIC GmbH
System-Manual
5 6...13
UID
7 6
0 0
addressed
Parameters, I-Code-Mode).
14 15...18
CB-ADR CB
5 4
0 0
6.1.3. [0x22] Lock Multiple Blocks
Page 77 of 131
ID ISC.MR/PR/PRH101
ANNEX G: Memory Model I-
3 2 1
0 ADR
H60301-3e-ID-B.doc
0
should