Annex D: Index Of Status Bytes - Feig Electronic OBID i-scan ID ISC.PR101 Manual

®
OBID i-scan

ANNEX D: Index of Status Bytes

Hex-value
0x00
OK:
• Data / parameters have been read or stored without error
•
Control command has been executed
Hex-value
0x01
No Transponder:
• No Transponder is located within the detection range of the Reader.
• The Transponder in the detection range has been switched to mute.
•
The communication between Reader and Transponder has been interfered and the Reader
is not able to read the Transponder anymore.
0x02
Data False:
•
CRC16 data error on received data.
0x03
Write-Error:
Negative plausibility check of the written data:
• Attempt to write on a read-only storing-area.
• Too much distance between Transponder and Reader antenna.
•
Attempt to write in a noise area.
0x04
Address-Error:
The required data are outside of the logical or physical Transponder-address area:
• The address is beyond the max. address space of the Transponder.
•
The address is beyond the configured address space of the Transponder.
0x05
Wrong Transponder-type:
This command is not applicable at the Transponder:
• Attempt to write on or read from a Transponder.
•
A special command is not applicable to the Transponder.
FEIG ELECTRONIC GmbH
System-Manual
General
Transponder Status
Page 121 of 131
ID ISC.MR/PR/PRH101
H60301-3e-ID-B.doc