Protocols For Iso15693 Host Commands - Feig Electronic OBID i-scan ID ISC.PR101 Manual

®
OBID i-scan

6. Protocols for ISO15693 Host Commands

Some ISO15693Host commands can be used to access I-Code 1 Transponders. The additional com-
mands Read Config Block and Write Config Block were created by FEIG ELECTRONIC to provide
full Transponder configuration capabilities for I-Code 1 Transponders via the OBID
model (see ANNEX G: Memory Model I-Code 1
ble:
6.1. [0xB0] Host commands for ISO15693 Mandatory
and Optional Commands
6.1.1. [0x01] Inventory
6.1.2. [0x02] Stay Quiet
6.1.3. [0x22] Lock Multiple Blocks
6.1.4. [0x23] Read Multiple Blocks
6.1.5. [0x24] Write Multiple Blocks
6.1.6. [0x25] Select
6.1.7. [0x26] Reset to Ready
6.1.8. [0x27] Write AFI
6.1.9. [0x28] Lock AFI
6.1.10. [0x29] Write DSFI
6.1.11. [0x2A] Lock DSFI
6.1.12. [0x2B] Get System Information
6.1.13. [0x2C] Get Multiple Block Security Status
6.1.14. [0xA0] Read Config Block
6.1.15. [0xA1] Write Config Block
8. [0xB1] Host commands for ISO15693 Custom and
Proprietary Commands
8.6. [0xBF] ISO15693 Transparent Command
1
only Philips I-Code UID
2 3
Read and Write Config Block will only be available if the I-CODE_MODE (MAPPING)is set to "FEIG Memory
Model" see: 3.5. CFG4: Transponder Parameters
FEIG ELECTRONIC GmbH
System-Manual
Transponders). The following combinations are possi-
Transponder Types
I-Code 1 ISO15693
√ √
√ √
√
√
√ √
√ √
√
√
√
√
√
√
√
√
2
√
3
√
√
√
Page 57 of 131
ID ISC.MR/PR/PRH101
®
i-scan memory
I-Code
EPC/UID
√
√
1
√
√
H60301-3e-ID-B.doc