Starting The Program - Extron electronics FOXBOX Tx HDMI User Manual

High resolution fiber optic transmitters and receivers

Hide thumbs Also See for FOXBOX Tx HDMI:

Table of Contents

Starting the Program

Start the Extron FOX Extenders program as follows:

Click Start > Programs > Extron Electronics > FOX Extenders

Control Program > FOX Extenders.

The Communication Setup window appears (see figure 15).

Figure 15.

Select the Com port to which your transmitter or receiver is connected. Click OK. The

FOX Extenders Control Program window appears (see figure 16).

Figure 16.

NOTES:

Communication Setup Window

FOX Extenders Control Program Window

Figure 16 is an amalgam of program displays. Some controls and displays

•

are available when connected to the transmitter only and some when

connected to the receiver only. These functions are identified in the

descriptions that follow.

• Only one fiber optic cable, transmitter-Tx-to-receiver-Rx, is required for

serial command transmission. But, if you connect only one fiber optic

cable, the transmitter will not receive reports from the controlled device.

For the transmitter to receive responses from the controlled device,

you must install two fiber optic cables and leave link 2 enabled (via an

SIS command

to the receiver or using the

Program).

FOX Extenders Control

FOXBOX Tx/Rx HDMI • Remote Control

Table of Contents

Do you have a question about the FOXBOX Tx HDMI and is the answer not in the manual?

Foxbox rx hdmi