Dmx Control - ADJ ELEMENT HEXIP User Instructions

Element HEXIP
DMX Mode:
Operating through a DMX controller gives the user the freedom to create their own programs tailored
to their own individual needs. To control this unit in DMX mode, your contoller must be connected
to a Wifly TranCeiver. This is a Wifly unit only. The Element HEXIP has 5 DMX modes: 6 channel
mode, 7 channel mode, 8 channel mode, 11 channel mode, and 12 channel mode. See pages 13-15
for each mode's DMX traits.
1. This function will allow you to control each individual fixture's traits with a standard DMX 512
controller. Please see pages 20 & 21 "WiFly Set Up" for more information.
2. To run your fixture in DMX mode press the MODE button until "d.XXX" is displayed. "XXX" represents
the current displayed DMX address. Use the UP or DOWN buttons to select your desired DMX
address, then press the SETUP button to select your DMX Channel mode.
3. Use the UP or DOWN buttons to scroll through the DMX Channel modes. The Channel modes
are listed below:
• To run the 6 Channel Mode, press the MODE button until "Ch06" is displayed.
• To run the 7 Channel Mode, press the MODE button until "Ch07" is displayed.
• To run the 8 Channel Mode, press the MODE button until "Ch08" is displayed.
• To run the 11 Channel Mode, press the MODE button until "Ch011" is displayed.
• To run the 12 Channel Mode, press the MODE button until "Ch012" is displayed.
4. Please see pages 13-15 for DMX values and traits.
ADJ Products, LLC - www.adj.com - Element HEXIP User Manual Page 12

DMX Control