Master-Slave Set Up - ADJ MOD STQ User Instructions

MOD STQ
INFORMATION - The submenus listed under INFORMATION are as follows: Fixture Hours, Fixture
Temperature, and Software Version.
- HOURS (FIXTURE HOURS)
• PwrOnHr1 -The TOTAL power ON running time of the unit is displayed. This time CANNOT be
reset.
• PwrOnHr2 - The CURRENT power ON running time of the unit is displayed. This running time may
not be the same as the total power ON running time displayed under "Power On Time". This time
CAN be reset.
• PwrOnRst - Reset the current power ON running time that is displayed under "PwrOnHr2".
- INFORMAT TMP (FIXTURE TEMPERATURE)
XXX F / XXX C - Current temperature
- INFORMAT VX.XX (Software Version) - Current software version is displayed.
MOD STQ

Master-Slave Set Up:

This function will allows the user to link units together to run in a Master-Slave set-up. In a Master-
Slave set up, one unit will act as the controlling unit and the others will react to the controlling units
operating mode. Any unit can act as a Master or as a Slave, however, only one unit can be programmed
to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data
cables to link your units together. Remember that the Male XLR connector is the input and the
Female XLR connector is the ouput. The first unit in the chain (master) will use the female XLR
connector only. The last unit in the chain will use the male XLR connector only.
2. Connect the first "Slave" unit to the "Master."
3. "Master" Unit: Activate the "Master" setting located in the "PERSNLTY" menu.
"Slave" Unit(s): Activate the "Slave" setting located in the "PERSNLTY" menu.
4. Set the "Master" unit to your desired mode of operation.
5. The slave unit(s) will now follow the master unit.
ADJ Products, LLC - www.adj.com - MOD STQ User Manual Page 18
System Menu
Master-Slave Set Up