Master-Slave Set Up - ADJ Startec Series User Instructions

Mini Dekker LZR
Universal DMX Control:
sal DMX-512 controller to control the patterns, rotation and strobing.
A DMX controller allows you to create unique programs tailored to
your individual needs.
1. The Mini Dekker LZR has two DMX channel modes; a 2 channel
mode and a 7 channel mode. See page's 19-20 for detailed
description of the DMX values and traits.
2. To control your fixture in DMX mode, follow the set-up procedures
on pages 7-8 as well as the set-up specifications that are
included with your DMX controller.
3. Follow the instructions on page 12 to set the DMX address.
4. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
5. For help operating in DMX mode consult the manual included
with your DMX controller.
Sound Active Mode:
This mode allows a single unit or several units
linked together, to run to the beat of the music.
1. Press the MENU button until "Soun" is displayed, and press
ENTER.
2. Press the UP or DOWN buttons to either activate sound active
mode or deactivate, and press ENTER. The unit will now run to
the beat of the music.
3. The sound sensitivity can be adjusted by turning the sound sensi-
tivigy knob located on the back of the unit. Turning the knob
clockwise is most sensitive and turn it counter-clockwise is least
sensitive.
Show Mode:
This mode allows a single unit or several units linked
together, to run to a built-in program.
1. Press the MENU button until "Show" is displayed, and press
ENTER to activate.
ADJ Products, LLC - www.adj.com - Mini Dekker LZR Instruction Manual Page 16
Operating Instructions
This function allows you to use a univer-
Mini Dekker LZR
Master-Slave Operation:
16 units together and operate without a controller. In a Master-Slave
set-up one unit will act as the controlling unit and the others will react
to the controlling units programs. Any unit can act as a Master or as a
Slave.
1. Using standard XLR microphone cables, daisy chain your units
together via the XLR connector on the rear of the units. Remem-
ber the Male XLR connector is the input and the Female XLR
connector is the output. The first unit in the chain (master) will use
the female XLR connector only - The last unit in the chain will use
the male XLR connector only. For longer cable runs we suggest a
terminator at the last fixture.
2. Set the Master to your desired operating mode.
3. Set the Slave unit(s) to address "001".
4. The slave unit(s) will now follow the Master unit.
ADJ Products, LLC - www.adj.com - Mini Dekker LZR Instruction Manual Page 17

Master-Slave Set Up

This function will allow you to link up to