Operation; Master-Slave Set Up - ADJ SABER SPOT RGBW User Instructions

Saber Spot RGBW
Universal DMX Control:
versal DMX-512 controller to control the colors, master dimmer and
strobe. A DMX controller allows you to create unique programs tai-
lored to your individual needs.
1. The Saber Spot RGBW has 12 DMX channel modes. See pages
17-26 for detailed description of the DMX values and traits.
2. To control your fixture in DMX mode, follow the set-up procedures
on pages 7-9 as well as the set-up specifications that are includ-
ed with your DMX controller.
3. Use the controller's faders to control the various DMX fixture traits.
4. This will allow you to create your own programs.
5. Follow the instruction on page 9 to select your DMX channel
mode and set your desired DMX address.
6. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
7. For help operating in DMX mode consult the manual included
with your DMX controller.
Show Mode:
This mode allows either a single unit or several units
linked together to run a built-in program.
1. Press the MENU button until "Look" is displayed, and press
ENTER.
2. Press the UP or DOWN buttons to find your desired show.
ADJ Products, LLC - www.adj.com - Saber Spot RGBW Instruction Manual Page 14

Operation

This function allows you to use a uni-
Saber Spot RGBW
Master-Slave Operation
16 units together and operate without a controller. In a Master-Slave
set up, one unit will act as the controlling unit and the others will react
to the controlling units programs. Any unit can act as a Master or as a
Slave.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. On the Master unit find your desired operating mode.
3. On the slave units press the MENU button until "Slave" is dis-
played.
4. The slave units will now follow the Master unit.
Saber Spot RGBW
The Saber Spot RGBW Plus comes with 2 frost filters. Install the filter
in front of the lens and put the inlcuded retainer ring on top of the lens
to hold it in place.
ADJ Products, LLC - www.adj.com - Saber Spot RGBW Instruction Manual Page 15

Master-Slave Set Up

This function will allow you to link up to
Installing the Frost Lens