Overview - ADJ ELEMENT HEXIP User Instructions

Element HEXIP
1
2
1. Service Port: This port is used for software updates.
2. Battery On/Off Switch: This switch is used to turn ON battery power and also turn ON the PCB
output. See page 17 "Load Setting" to activate.
3. Kickstand: This kickstand is used to angle the unit to various degrees. There are 3 different
degree levels. Note: Be very cautious at the degree in which you angle the unit at, due to the fact
that it could fall over.
4. Power Input & Fuse Holder: This input is used to connect the included I.E.C. power cord. After
connecting the power cord, plug the other end into a matching power source. Located inside the
power socket is the fuse housing. See page 25 for fuse replacement.
5. Mode Button: This button lets you scroll through the system menu.
Setup Button: This button lets you access the submenus.
Up & Down Button: These button's are used to scroll through submenus and make adjustments
in the submenu's.
6. Digital Display: This will display the various menus, submenus, and adjustments.
7. Control Panel Access Door: Lifting this door will allow you to access the controls and functions.
ADJ Products, LLC - www.adj.com - Element HEXIP User Manual Page 10
3

Overview

7
6
5
4