Table of Contents
Advertisement
SYSTEM MENU (continued)
Unit Temperature
- In this menu you can switch the running temperature between fahrenheit and
celsius.
1. Press the MODE button until "TempUnit" is displayed.
2. Press ENTER to change the running temperature When you press ENTER the current temperature setting
will begin to flash. Use the UP and DOWN buttons to switch between the temperature settings.
Temperature
- In this menu you check the current running temperature.
1. Press the MODE button until "Temp." is displayed.
2. The current running temperature will now be displayed.
White Balance
- In this menu you can adjust/balance the colors.
1. Press the MODE button until "Whitebal." is displayed.
2. Press the ENTER button and the "LED" number will begin to blink. Use the UP or DOWN buttons to find the
head you would like to balance and press ENTER.
3. Use the UP or DOWN buttons scroll through the colors. Once you find the color you would like to adjust
press ENTER.
4. Use the UP or DOWN buttons to adjust the color.
Default Settings
- In this menu you can reset the unit back to its default settings.
1. Press the MODE button until "DFSE." is displayed.
2. Press the ENTER button and either "ON" or "OFF" will be displayed. To reset the unit, use the UP or DOWN
buttons to display "ON" and press ENTER.
DMX CONTROL
Universal DMX Control: This function allows you to use a universal DMX-512 controller to control the colors,
chases, dimmer and strobe. A DMX controller allows you to create unique programs tailored to your individual
needs.
1. The Penta Pix has 5 DMX Modes; a 4 Channel Mode, 8 Channel Mode, 11 Channel Mode, 20 Channel
Mode & 27 Channel Mode. See pages 10-14 for a detailed description of the DMX traits.
2. To control your fixture in DMX mode, follow the set-up procedures on pages 5-6 as well as the set-up
specifications that are included with your DMX controller.
3. Use the controller's faders to control the various DMX fixture traits. This will allow you to create your own
programs.
4. Follow the instructions on page 7 to select your desired DMX Mode and to set the DMX address. After you
have selected your DMX mode and set the address, then connect your DMX controller.
5. For longer cable runs (more than a 100 feet) use a terminator on the last fixture.
6. For help operating in DMX mode consult the manual included with your DMX controller.
MASTER-SLAVE SET UP
Master-Slave Set Up: This function will allow you to link up to 16 units together and operate without a
controller. In a Master-Slave set up one unit will act as the controlling unit and the others will react to the
controlling units programs. Any unit can act as a Master or as a Slave.
1. Using appropriate XLR cables, daisy chain your units together via the XLR connector on the rear of the
units. Remember the Male XLR connector is the input and the Female XLR connector is the output. The first
unit in the chain (master) will use the female XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a terminator at the last fixture.
2. Set the Master unit to your desired operational mode.
3. On the slave units press the MODE button until "SLAVE MODE" is displayed.
4. The slave units will now follow the Master unit.
A.D.J. Supply Europe B.V. – www.americandj.eu – Penta Pix Instruction Manual Page 9
Advertisement
Table of Contents
