Master-Slave Set Up; Power Cord Daisy Chain; Emergency Blackout; Uc Ir/Airstream Control - ADJ Stinger II User Instructions

MASTER-SLAVE SET UP

Master-Slave Operation: This function will allow you to link up to 16 units together and operate without a
controller. In a Master-Slave set-up one unit will act as the controlling unit and the others will react to the
controlling units programs. Any unit can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units together via the XLR connector on the rear of the
units. Remember the Male XLR connector is the input and the Female XLR connector is the output. The first
unit in the chain (master) will use the female XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a terminator at the last fixture.
2. On the Master unit press the MENU button until "SLND" is displayed, and press ENTER. Use the UP and
DOWN buttons to scroll to the "MAST" setting and press ENTER.
3. After setting the Master unit to the master setting find and set your desired operating mode.
4. On the slave units press the MENU button until "SLND" is displayed, and press ENTER. Choose either "SL
1" or "SL 2" and press ENTER. See page 10 for more info.
5. The slave units will now follow the Master unit.

POWER CORD DAISY CHAIN

With this feature you can connect the fixtures to one another using the IEC input and output sockets.
The quantity that can be connected is 10 fixtures maximum. After 10 fixtures you will need to use a
new power outlet. They must be the same fixtures. DO NOT mix fixtures

EMERGENCY BLACKOUT

This emergency feature lets you instantly blackout the unit. Have the emergency key inserted into the keyhole
at all times. To activate the emergency blackout feature turn it to the "Off" position. To reactivate the unit turn
the key to the "On" position.

UC IR/AIRSTREAM CONTROL

The UC IR (sold separately) infrared remote gives you control of various functions (See below). To control
the fixture you must aim the remote at the front of the fixture and be no more than 30 feet away.
The Stinger II comes with the Airstream IR remote transmitter. The ADJ Airstream IR is a universal infrared
remote control App used to control a variety of UC IR compatiable fixtures. You can download the Airstream IR
App in the iOS App store. The remote transmitter plugs into the headphone jack of your iOS phone or tablet.
The App comes with 3 pages of control depending on the IR fixture you are using. Please see your fixtures
user manual for the UC IR controls and corresponding App page. Additional Airstream IR transmitters are
available for purchase please contact your ADJ dealer.
Works with App page 1.
STAND BY - Pressing this button will blackout the fixture. Press the button again to return to the initial state.
FULL ON - Hold this button down to fully light up the unit. When you let the button go, the unit will return to its
previous state.
STROBE - Press and hold this button for strobing.
FADE/GOBO - This button is invalid for this fixture.
"DIMMER +" and "DIMMER -" - These buttons are invalid for this fixture.
COLOR - Press this button to activate color mode. Use buttons 1-9 to find your desired color.
1-9 - Use buttons 1-9 to select your desired color when color mode is active.
SOUND ON & OFF - Use the buttons to activate and deactivate sound active mode.
SHOW 0 - Press this button to activate show mode. Use buttons 1-6 to find your desired show.
A.D.J. Supply Europe B.V. – www.americandj.eu – Stinger II Instruction Manual Page 12