Operating Instructions - ADJ ELEMENT HEXIP User Instructions

Element HEXIP
Operating Power:
There are two ways to supply power to this unit; battery power or AC power. Note: You need to
activate the LOAD function regardless of how you supply power.
• AC Power - To run the unit using AC power, plug the unit into a power source, and activate the
Load setting. When using AC power make sure the Battery Switch is in the OFF position.
• Battery Power - To run the unit using Battery power, switch the battery switch located on the bottom
of the fixture into the "On" postion, and activate the Load setting.
Load Setting
This function needs to be activated regardless of using Battery power or AC power. This will
activate LED PCB output.
1. To activate Load, press the MODE button until either "bXXX", "bsXX", or "LoXX" is displayed.
"XX" is the represents the current setting of those menus.
2. Press the SET UP button so that "LoXX" is displayed. "XX" represents either "on" or "oF" (Off).
3. Press the UP or DOWN buttons so that "on" is displayed.
Energy Saving Mode
This will decrease the LED's brightness gradually when the battery life is less than 80%, this is will
extend the battery life.
1. To activate energy saving mode, press the MODE button until either "bXXX", "bsXX", or "LoXX"
is displayed. "XX" represents the current setting of the displayed menu.
2. Press the SET UP button so that "bS:XX" is displayed. "XX" represents either "on" or "oF" (Off).
3. Press the UP or DOWN button so that "on" is displayed. If "on" is displayed then the fixture is
already in energy saving mode.
Display Lock:
1. Plug the fixture in and press the MODE button until "dXX" is displayed. "XX" represents either
"on" or "off".
2. Plug the fixture in and press the SET UP button until "LoCX" is displayed. "X" represents an
number between 1-3.
3. Press the UP or DOWN buttons to find your desired setting.
• "LoC1" - The keypad will remain unlocked at all times.
• "LoC2" - The keypad will lock after 10 seconds, press the MODE button for 3 seconds to unlock
the keypad.
• "LoC3" - This lock setting is used to prevent the accidental unlocking of the keypad. To unlock
the keypad press UP, DOWN, UP, DOWN, in that order.
LED Display On/Off:
To set the LED display light to turn off after 20 seconds, press the MODE button until "dXX" is displayed.
"XX" represents either "on" or "oFF". Press the UP or DOWN buttons so that OFF is displayed. Now
the display light will turn off after 30s. Press any button to turn the display on again.
ADJ Products, LLC - www.adj.com - Element HEXIP User Manual Page 17

Operating Instructions