Hv-2000C Front And Rear Features - Graco Advanjet Diaphragm-Jet HV-2000 Setup And Operation

1.5

HV-2000C Front and Rear Features

ILLUMINATES WHEN
TRIGGER BUTTON
EXECUTES THE
DISPENSING RECIPE
ON LCD DISPLAY
(ONCE)
JET
PRESSURE GAUGE
DISPLAYS JET
ACTUATION PRESSURE
RS-232 PORT
CONNECTS HV-2000C
TO A PC VIA SERIAL
DB9-TO-USB CABLE
ACTUATION PRESSURE
PROVIDES FLUID DELIVERY AIR PRESSURE;
CONNECT TO THE FLUID SYRINGE WITH A 4-MM Ø HOSE
LCD CONTRAST
ADJUSTS THE
CONTRAST LEVEL
ON THE LCD
DISPLAY; ROTATE
THE SWITCH WITH
A SMALL
SCREWDRIVER
AC CONNECTOR
WITH FUSE
100 TO 240 VAC.
REQUIRED FUSE:
5X20 MM, FAST-
ACTING, 1 AMP,
250 VAC. OPERATE
IN OTHER
COUNTRIES USING
LOCAL POWER
CORD.
PC RUNNING THE ADVANJET SOFTWARE WITH A
SERIAL DB9-TO-USB CABLE OR A USB-TO-RS-232C
CONVERTER CABLE WITH CORRESPONDING DRIVER
3A5856A
TRIGGER LED
MOVES LCD DISPLAY CURSOR,
DISPENSING CHANGES PARAMETER VALUES
JET PRESSURE
CONTROLLER
REGULATES JET REGULATES DISPENSING
Figure 1-1: HV-2000C Front Panel
FLUID PRESSURE OUTLET
RS-232 INTERFACE
CONNECTS THE HV-2000C TO A
Figure 1-2: HV-2000C Rear Panel
Advanjet HV-2000C Jet Controller Setup and Operation
KEYPAD
TEMPERATURE
CONTROLLER
NOZZLE TEMPERATURE
JET PRESSURE OUTLET
PROVIDES JET DISPENSER AIR PRESSURE;
CONNECT WITH A 6-MM Ø HOSE
JET CONNECTOR
SENDS OUTPUT TRIGGER SIGNALS FOR THE DISPENSING
JET AND HEATER SETTINGS
**MUST USE THE ADVANJET CABLE SUPPLIED WITH THE
SYSTEM TO CONNECT WITH THE HV-2000 JET
LCD DISPLAY
SHOWS PROGRAM
PARAMETERS
POWER SWITCH
TURNS THE
HV-2000C
MAIN POWER
ON/OFF
FLUID
PRESSURE GAUGE
DISPLAYS FLUID
DELIVERY PRESSURE
AIR SWITCH
PROVIDES
QUICK ON/OFF
CONTROL OF FLUID
DELIVERY PRESSURE
FLUID PRESSURE
CONTROLLER
REGULATES FLUID
DELIVERY PRESSURE
AIR INLET
CONNECTS TO
THE SOURCE
PRESSURE WITH A
6-MM Ø HOSE
I/O CONNECTOR
TRIGGERS THE
DISPENSING
RECIPES AND
OUTPUTS, BUSY
FLAG, AND ERROR
SIGNALS FROM
THE HEATER
CONTROLLER AND
PRESSURE
GAUGES; USES A
STANDARD
5-FOOT 26-PIN
CABLE
Page 9 of 60