Appendix 2: Temperature Controller Factory Settings - Graco Advanjet Diaphragm-Jet HV-2000 Setup And Operation

Appendix 2: Temperature Controller Factory Settings

The CN740 Temperature Controller manual is included with your Advanjet controller shipment.
Listed below are factory set values programmed by Advanjet to work with the HV-2000C
controller and the HV-2000 Jet Nozzle plate for the majority of applications. It is strongly
recommended that users do not modify these values.
Use the   keys to adjust values. Press
again to return to the previous menu.
OPERATION
Press
REGULATION
Press once, then press
INITIAL SETTINGS
Press and hold
3A5856A
Please refer to it for specific instructions.
Description
Control Run/Stop setting
Upper-limit alarm 1
Lower-limit alarm 1
Upper-limit alarm 2
Lower-limit alarm 2
Description
PB (Proportional band)
Ti (Integral time)
Td (Derivative time)
Default value of Integral Volume
Heating Control Cycle Setting
Process Temperature Offset
Description
Input temperature sensor type
Temperature unit display selection
Upper-limit of temperature range
Lower-limit of temperature range
Control method
Heating/Cooling control Selection
Alarm 1 type
Alarm 2 type
Data Format
Advanjet HV-2000C Jet Controller Setup and Operation
once to save changes, and press
Setting
AL1H
AL1L
AL2H
AL2L
Setting
HtPd
tPoF
Setting
tPUn
tP-H
tP-L
S-HC
ALA1
ALA2
C-5L
Value
r-S
3
3
3
3
LOC oFF
Value
P 4
i 20
d 5
ioF 0
10
0
Value
inPt Pt2
C
75
-20
Ctrl PiD
HEAt
1
1
ASCII
Page 43 of 60