Appendix 4-1:
Analog input
AIN 5
11-bit res. channel, software-selectable ranges
11
unipolar: 1, 2, 2.5, 5, 10, 20 V DC; bipolar ± 1, ±2, ±5, ±10 V DC;
4 channels can be hardware-configured for 4–20 mA;
1 MÙ input impedance, up to 4,100 samples/s
Analog Input
AIN 7
11-bit res. channel, software-selectable ranges
12
unipolar: 1, 2, 2.5, 5, 10, 20 V DC; bipolar ± 1, ±2, ±5, ±10 V DC;
4 channels can be hardware-configured for 4–20 mA;
1 MÙ input impedance, up to 4,100 samples/s.
Analog output
AOUT 1
13
12-bit res. channel, buffered, 0–10 V DC, ±10 VDC,
and 4–20 mA, update rate 12 kHz.
GND
14
ANALOG GROUND
15
No connection.
16
No connection.
17
No connection.
18
Heater Alarm Common (Output)
Fluid Pressure Alarm Common (Output)
19
Optional alarm. Not normally programmed for use.
Fluid Pressure Alarm 2 (Output)
20
Optional alarm. Not normally programmed for use.
Fluid Pressure Alarm 1 (Output)
21
Optional alarm. Not normally programmed for use.
Jet Pressure Alarm Common (Output)
22
Optional alarm. Not normally programmed for use.
Jet Pressure Alarm 2 (Output)
23
Optional alarm. Not normally programmed for use.
Jet Pressure Alarm 1 (Output)
24
Optional alarm. Not normally programmed for use.
Heater Alarm 1 (Output)
Single Pole, Single Throw, Normally open relay contact, 3A, 250
VAC. When closed, pin 25 is connected to pin 18, Heater Alarm
25
Common.
Optional alarm. Not normally programmed for use.
May be configured to create an alarm for 12 different fault conditions.
Heater Alarm 2 (Output)
Single Pole, Single Throw, Normally open relay contact, 3A, 250
VAC. When closed, pin 26 is connected to pin 18, Heater Alarm
26
Common.
Optional alarm. Not normally programmed for use.
May be configured to create an alarm for 12 different fault conditions.
Page 54 of 60
HD26 Pin Assignments (Continued)
Advanjet HV-2000C Jet Controller Setup and Operation
Buffered A/D
Converter Inputs
Buffered A/D
Converter Inputs
D/A Converter
Outputs
Pressure Alarm
Input/Output
Circuit (AP-
C30K/C31K/C33K)
3A5856A