Lightware VINX-110-HDMI-DEC User Manual page 56

   
5. Programmers' Reference
Setting the Signal Type of the Output Video Signal
SET•/MEDIA/VIDEO/<out>/SCALER.SignalType=<sig_type>
ç
Querying the State of the USB Connection
ç GET•/MEDIA/KM.Controlling
Establishing the USB Connection
ç CALL•/MEDIA/KM:acquireControl(true)
Audio-related Commands
Querying the Audio Input Selection Mode
ç GET•/MEDIA/AUDIO.ioSelect
Setting the Audio Input Selection Mode
SET•/MEDIA/AUDIO.ioSelect=<sel_mode>
ç
Querying the Audio Signal Presence
ç GET•/MEDIA/AUDIO/<in>.SignalPresent
Querying the Volume (Exact Value)
ç GET•/MEDIA/AUDIO/<port>.AnalogVolumedB
Setting the Volume (Exact Value)
SET•/MEDIA/AUDIO/<port>.AnalogVolumedB=<value>
ç
Setting the Volume (by a Step Value)
CALL•/MEDIA/AUDIO/<port>:stepVolumeDb=<value>
ç
Querying the Volume (in Percentage)
ç GET•/MEDIA/AUDIO/<port>.AnalogVolume
Setting the Volume (in Percentage)
SET•/MEDIA/AUDIO/<port>.AnalogVolume=<value>
ç
Setting the Volume (by a Step Value in Percantage)
CALL•/MEDIA/AUDIO/<port>:stepVolumePercent=<value>
ç
Querying the Mute State
ç GET•/MEDIA/AUDIO/<port>.AnalogMute
Setting the Mute State
ç GET•/MEDIA/AUDIO/<port>.AnalogMute
VINX-1x0-HDMI Extenders – User's Manual
Serial Port Settings
Setting the Port Availability
SET•/MEDIA/UART/<port>.Enabled=<port_status>
ç
Setting the Baud Rate of the Port
SET•/MEDIA/UART/<port>.Baudrate=<Baud_value>
ç
Setting the RS-232 Port Mode
SET•/MEDIA/UART/<port>.Guest=<port_mode>
ç
Setting the Data Bits
SET•/MEDIA/UART/<port>.DataBits=<Databits_value>
ç
Setting the Stop Bits
SET•/MEDIA/UART/<port>.StopBits=<Stopbits_value>
ç
Setting the Parity
SET•/MEDIA/UART/<port>.Parity=<parity_setting>
ç
Arranging the Extenders to Groups
Querying the Working Mode (Unicast/Multicast)
ç GET•/MANAGEMENT/MULTICAST.MulticastMode
Setting the Working Mode (Unicast/Multicast)
SET•/MANAGEMENT/MULTICAST.MulticastMode=<Multicast_mode>
ç
Querying the Video Stream ID Setting Method
ç GET•/SYS/MB/PHY.ChannelIdSetBySoftware
Querying the DIP Switch Value
ç GET•/SYS/MB/GPIO.DipSwitch
Querying the Video Stream ID
ç GET•/SYS/MB/PHY.VideoChannelId
DIP Switch Enable
SET•/SYS/MB/GPIO.DipSwitchEnable=<switch_valid>
ç
Setting the Video Stream ID
SET•/SYS/MB/PHY.VideoChannelId=<channel_ID>
ç
56