Table of Contents
Advertisement
03/2006
3.6
MPI interface for customer's operating panel
Interface
The interface is used to connect a customer's operating panel. The module has
64 digital inputs and 64 digital outputs with C-MOS level (5V) for this purpose.
The module must have at least firmware release V 03_01_01.
Position of the
interfaces
Fig. 3-8
Switch S3, default
If only the customer's operating panel is connected, the bus address should be
set to 6 as for the MSTT (standard application).
setting for
SINUMERIK 840D
Table 3-5
on
Switch S3, default
If only the customer's operating panel is connected, the bus address should be
set to 14 as for the MSTT (standard application).
setting for
SINUMERIK 810D
Table 3-6
off
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D/810D Start-Up Guide (IADC) – 03/2006 Edition
3.6
MPI interface for customer's operating panel
64.7
X20
MPI connection
Equipotential bonding connection
X10
ON
"
S3
7.2
207.3
Front view of MPI interface for customer's operating panel
Setting for 840D: switch S3 interface for customer's operating panel
1
2
3
4
5
off
on
off
on
on
Setting for 810D: switch S3 interface for customer's operating panel
1
2
3
4
5
off
on
on
on
on
3 Settings, MPI/BTSS
289.4
X211
X221
Holes 3.6
6
7
8
Meaning:
off
on
Baud rate: 1.5 MBaud (BTSS)
Cyclical transmission interval:
100 ms
Bus address: 6
6
7
8
Meaning:
off
on
Baud rate: 187.5 kBaud
Cyclical transmission interval:
100 ms
Bus address: 14
X231
92.7
H3
H1
3.5
LEDs
H4
H2
3-31
3
Advertisement
Table of Contents
