VETRON 5000 Instruction Book page 16

INSTRUCTION BOOK
12. INSERTING THE NEEDLE (ONE NEEDLE MACHINE)
-1-2
1
2
CAUTION! RISK OF INJURY!
Push the X-button at the machine head, the red light illuminates showing the active
"BLOCKED MODE" or turn the machine o , before inserting the needle. Failure to
comply produces a risk of injury in case of an unintentional machine operation.
CAUTION!
Only use needles from the system intended for the machine.
(Needle lsystem 134-35)
01. Push the X-button at the machine head, the red light illuminates showing
the active "BLOCKED MODE", or turn the machine o .
02. Loosen the screw 1 .
03. Push the needle 2 fully in until it stop. Make sure that the groove
on the needle is to the right side.
04. Tighten the screw 1 again.
05. Push the X-button or switch the machine on again and follow the instructions
displayed in the control panel.
CAUTION:
Before activating the machine by the X-button make sure to remove sewing mate-
rial or other items below the sewing feet if necessary and follow the instructions
displayed on the control panel.
08/2017
16
VETRON 5000/5100 - FLAT BED MACHINE
3
3