VETRON 5000 Instruction Book page 17

1
2
CAUTION! RISK OF INJURY!
Push the X-button at the machine head, the red light illuminates showing the active
"BLOCKED MODE", or turn the machine o before inserting the needles. Failure to
comply produces a risk of injury in case of an unintentional machine operation.
CAUTION!
Only use needles from the system intended for the machine.
(Needle lsystem 134-35)
01. Push the X-button at the machine head, the red light illuminates showing
the active "BLOCKED MODE", or turn the machine o .
02. Loosen the screws
03. Push the needles
of the right needle points to the right and the left needle to the left.
04. Tighten the screws
05. Push the X-button or switch the machine on again and follow the instructions
displayed on the control panel.
CAUTION:
Before activating the machine by the X-button make sure to remove
sewing material or other items below the sewing feet if necessary and
follow the instructions displayed on the control panel.
12.01. INSERTING THE NEEDLE (TWO NEEDLE MACHINE)
1 .
2 fully in until they stop. Make sure that the groove
1 again .
INSTRUCTION BOOK
3
3
VETRON 5000/5100 - FLAT BED MACHINE
-2-2
08/2017
17