Set The Rta6 Slide-In Module Address; Insert The Rta6 Slide-In Module Into The Housing Of The Data Logger - Ahlborn ALMEMO 500 Supplementary Instructions Manual

5 How to use the RTA6 Slide-in Module

5.2 Set the RTA6 Slide-in Module Address

→ In case the RTA6 slide-in module is plugged into the data logger, remove the
RTA6 slide-in module from the data logger housing, see chapter 5.7
Remove RTA6 Slide-in module from the Housing of the Data Logger.
→ Turn the coding switch until the slit of the small wheel of the coding switch
points to the desired number.
The addresses of the individual RTA slide-in modules must be coded
in ascending order from 00 to 03. The first RTA slide-in module must
have the RTA slide-in module address 00.
RTA slide-in module
address 01
Several RTA6 slide-in modules must not have the same RTA slide-in
module address.
In the ALMEMO
to A3, depending on the RTA slide-in module address 00 to 03.
5.3 Insert the RTA6 Slide-in Module into the Housing of
the Data Logger
! The data logger must be switched off.
! The data logger must be disconnected from the power supply.
For the RTA6 slide-in module use the slide-in location next to the
slide-in location of the CPU card and the measuring circuit boards
(from the left to the right). If you want to use several RTA6 slide-in
modules, insert the RTA6 slide-in modules (RTA6 slide-in module
address ascending from left to right) into the slide-in locations of the
data logger.
3. Insert the RTA6 slide-in module into the data logger housing.
4. Fasten the knurled screws of the RTA6 slide-in module.
➢ The ON-LED lights as soon as the data logger is switched on.
- 10 –
Example:
®
500 app, the RTA slide-in module will be named A0