Information About The Pump (Information Menu); Set Language (Language Menu) - ProMinent Sigma/ 2 Control S2Cb Operating Instructions Manual

Setting
8.7.4.2 Password
8.7.4.3 Using Access protect and Password
Test
Overriding the Access protect.
Changing the stroke length variable

8.8 Information about the pump (INFORMATION menu)

Main menu
Mode
Settings
Service
Information
Language
Continuous
display

8.9 Set language (LANGUAGE menu)

62
In this menu enter the number you want to use as a password.
The password applies for both locks.
To test whether the menu is locked, press the
If you try to change into a locked area, a
To override the Access protect, enter the
[arrow keys] and press the [P/OK] key.
In the stroke adjustment dial has been turned, the padlock flashes, the
pump stops and a fault alert and key appear. If you enter the code, the
pump continues metering and the fault alert clears.
Information
Identcode
Serial number
Versions
End
In the "Info" sub-menu you can read off the following identification num‐
bers:
Identity Code
n
Serial number
n
Software versions
n
Hardware versions
n
Main menu
Settings
Service
Information
Language
End
Continuous
display
If an Access protect is then set after 1 minute a padlock
will appear instead of the " i " in the top left of the contin‐
uous display if in the meantime no key has been
pressed.
Versions
Software version
Hardware version
End
Language
German
English
French
Spanish
[P/OK] key for 2 s.
„Password" request appears.
„Password" using the
Software version
DATA: 00.03.06.03
HMI: 01.00.00.07
CTRL: 00.03.05.05
ESC
FC: 00.01.08.03
PFC: 00.00.03.00