Lcd Screen; Led Displays; Hierarchy Of Operating Modes, Functions And Fault Statuses - ProMinent Sigma/ 2 Control S2Cb Operating Instructions Manual

5.9 LCD screen

5.10

LED Displays

5.11

Hierarchy of operating modes, functions and fault statuses

If a fault occurs, the identifier
sage.
CANopen status display (green): The CANopen status indicator shows the
status of the CANopen bus.
Colour Flash code
green illuminated
green flashing
red any
Contact customer service in the event of all other flash codes.
Fault indicator (red): The fault indicator illuminates if a fault occurs e.g.
liquid level low 2nd stage".
Warning indicator (yellow): The warning indicator illuminates if the pump
electronics detect a condition which may lead to a fault, e.g. "liquid level
low 1st stage".
Operating indicator (green): The operating indicator illuminates provided
the pump is correctly connected to the operating voltage. The operating
indicator goes out briefly with every stroke.
The different operating modes, functions and fault statuses have a dif‐
ferent effect on if and how the pump reacts.
The following list shows the order:
1. - Priming
2. - Fault, Stop, Pause
3. - Auxiliary frequency (external frequency changeover)
4. - Manual, external contact, batch, external analog
Comments:
re 1 - "Priming" can take place in any mode of the pump (providing it is
functioning).
re 2 - "Fault", "Stop" and "Pause" stop everything apart from "Priming".
re 3 - The "Auxiliary frequency" stroke rate always has priority over the
stroke rate specified by an operating mode listed under 4.
Functional Description
„Error" appears and an additional error mes‐
Cause Conse‐
quence
Bus status Normal bus
mode
OPERA‐
TIONAL
Bus status currently no
measured
PRE-
value com‐
OPERA‐
munication
TIONAL
Bus error no meas‐
ured value
transmission
Remedy
-
wait briefly.
Disconnect
HMI then
reconnect
Check
whether the
CAN con‐
nection is
faulty.
Notify
Service
23