Electrical Installation, Control Terminals - Danfoss FC 300 Design Manual

FC 300 Design Guide

8.6.5 Electrical Installation, Control Terminals

To mount the cable to the terminal:
1. Strip insulation of 0.34–0.39 in [9–10 mm]
2. 1)
Insert a screwdriver in the square hole.
3. Insert the cable in the adjacent circular hole.
4. Remove the screwdriver. The cable is now mounted to the terminal.
To remove the cable from the terminal:
1. 1)
Insert a screwdriver in the square hole.
2. Pull out the cable.
1) Max. 0.015 x 0.1 in. [0.4 x 2.5 mm]
1.
MG.33.BC.22 - VLT ® is a registered Danfoss trademark
2.
8 Electrical Installation
8
3.
8-37