Danfoss FC 300 Design Manual page 267

FC 300 Design Guide
Bit 11, Relay 01:
Bit 11 = "0": Relay not activated. Bit 11 = "1": Relay 01 activated provided that
Bit 12, Relay 04:
Bit 12 = "0": Relay 04 is not activated. Bit 12 = "1": Relay 04 is activated provided that
Bit 13/14, Selection of set-up:
Use bits 13 and 14 to choose from the four menu set-ups according to
the shown table:
The function is only possible when
par. 0-10 Active Set-up .
Bit 15 Reverse:
Bit 15 = '0': No reversing. Bit 15 = '1': Reversing. In the default setting, reversing is set to digital in par. 8-54
only when Ser. communication, Logic or or Logic and is selected.
11.10.2 Status Word According to FC Profile (STW) (par. 8-10
Bit Bit = 0
00 Control not ready
01 Drive not ready
02 Coasting
03 No error
04 No error
05 Reserved
06 No error
07 No warning
Speed ≠ reference
08
09 Local operation
10 Out of frequency limit
11 No operation
12 Drive OK
13 Voltage OK
14 Torque OK
15 Timer OK
Explanation of the Status Bits
Bit 00, Control not ready/ready:
Bit 00 = '0': The adjustable frequency drive trips. Bit 00 = '1': The adjustable frequency drive controls are ready but the power component does not
necessarily receive any power supply (in case of external 24 V supply to controls).
Multi Set-ups
is selected in
MG.33.BC.22 - VLT ® is a registered Danfoss trademark
11 RS-485 Installation and Set-up
Control word bit 11
is chosen in par. 5-40
Control word bit 12
is chosen in par. 5-40
Set-up Bit 14
1 0
2 0
3 1
4 1
NOTE!
Make a selection in par. 8-55
how Bit 13/14 gates with the corresponding function
on the digital inputs.
Reverse Select
Control Profile
Bit = 1
Control ready
Drive ready
Enable
Trip
Error (no trip)
-
Triplock
Warning
Speed = reference
Bus control
Frequency limit OK
In operation
Stopped, auto start
Voltage exceeded
Torque exceeded
Timer exceeded
Function Relay
.
Function Relay
.
Bit 13
0
1
0
1
Set-up Select
to define
. Bit 15 causes reversing
= FC profile)
11
11-21