Mounting Of Options In Slot C - Danfoss FC 300 Design Manual

10 Options and Accessories

10.1.3 Mounting of Options in Slot C

The power to the adjustable frequency drive must be disconnected.
It is strongly recommended to make sure the parameter data is saved (e.g., by MCT10 software) before option modules are inserted/removed from the
drive.
When installing a C option, a mounting kit is required. Please refer to the
using MCB 112 as an example. For more information on installation of the MCO305, see the separate instruction manual.
10
If both C0 and C1 options are to be installed, the installation is carried out as shown below. Note that this is only possible for frame sizes A2, A3 and B3.
10-2
Frame sizes A2, A3 and B3
MG.33.BC.22 - VLT
How to Order section for a list of ordering numbers. The installation is illustrated
Frame sizes A5, B1, B2, B4, C1, C2, C3 and C4
® is a registered Danfoss trademark
FC 300 Design Guide