Assembling The Stand - DURKOPP ADLER 670 Operating Instructions Manual

66
7.3

Assembling the stand

Fig. 34: Assembling the stand
①
②
③
④
(1) - Head sections of the inner bars
(2) - Inner bars
(3) - Stand bars
(4) - Adjusting screw
To assemble the stand:
1. Screw the cross struts (7) to the stand bars (3).
2. Screw the oil can holder (8) at the rear to the upper cross
strut (7).
3. Screw the cross strut (5) to the foot struts (6).
4. Insert the inner bars (2) in such a way that the longer end
of the head sections (1) is above the longer end of the foot
struts (6).
5. Tighten the inner bars (2).
 Both head sections (1) must be at the same height.
Important
Turn the adjusting screw (4) so that the stand has even contact
with the ground.
(5) - Cross strut
(6) - Foot struts
(7) - Cross struts
(8) - Oil can holder
Operating Instructions 670/680 - 00.0 - 01/2017
Setup
⑧
⑦
⑥
⑤