Setting Speed Reduction During Stitch Loosening - DURKOPP ADLER 670 Operating Instructions Manual

Programming
Operating Instructions 670/680 - 00.0 - 01/2017
5.1.3

Setting speed reduction during stitch loosening

To set speed reduction during stitch loosening:
1. Press the
2. Set the parameters for the speed reduction during stitch
loosening: t 25 05.
• Use A+ to set the value to t.
• Use B+ to set the value to 25.
• Use D+ to set the value to 05.
3. Press the
4. Enter if speed reduction during stitch loosening is supposed
to be switched on:
• Use D+ to enter the value 1 = speed reduction on
• Use D+ to enter the value 0 = speed reduction off
5. Set the parameter for the rate to which the speed will be
reduced: t 25 06.
• Use A+ to set the value to t.
• Use B+ to set the value to 25.
• Use D+ to set the value to 06.
6. Enter the desired speed (0 - 2500 rpm).
7. To save the settings, press the
8. To switch to sewing mode, press the
button.
button.
button.
button
.
51