Adjusting The Drive Pulley - DURKOPP ADLER 967 Instruction Manual

6.1.2 Adjusting the drive pulley

Proper setting
Regardless of which side of the drive pulley (2) is being used, there is a
difference in height of 16 mm between the faces of the two pulleys.
Fig. 17: Adjusting the drive pulley
①
②
③
(1) - Driven pulley
(2) - Drive pulley
Setting steps
1. Loosen the screws (3).
2. Pull the drive pulley (2) off the motor shaft and put it back on the other
3. Set a height difference of 16 mm between the faces of the drive pulley
4. Tighten the screws (3).
26
WARNING
Risk of injury!
Crushing injuries from moving parts.
Switch off the machine before checking and setting
the drive pulley.
16 mm
way round.
(2) and the driven pulley (1).
Setting the drive
16 mm
(3) - Adjusting screws
Service Instructions 967 - 02.0 - 12/2015