2.7.3
Setting the left stop screw of the lift drive
1
Caution: Danger of injury!
Turn off the main switch.
Only check and adjust the stop screw when the sewing unit is
switched off.
Adjustment and inspection
The left stop screw 3 of the lift drive must be set so that lever 1 does
not perform lift if the stop block 2 touches the screw.
For this, the lift drive levers must be over covered.
–
Switch sewing unit off and on again.
–
Perform reference run with the machine.
–
Press button "Extras -> Service -> Multitest -> Set lift position".
–
Press button "Jump / Presser" until the presser foot is selected.
–
Turn hand crank and check if no lift is performed.
To adjust
–
Undo the counter nut 4.
–
Turn the stop screw 3 accordingly.
–
Screw up counter screw 4.
4
3
2
3
19