General Requirements; Local Commissioning Via Hmi; Local Display - Siemens SITRANS FC330 Operating Instructions Manual

Commissioning

6.3 Local commissioning via HMI

6.2

General requirements

Before commissioning it must be checked that:
● The device has been installed and connected in accordance with the guidelines provided
in Installing/mounting (Page 37) and Connecting (Page 57).
● Device installed in hazardous areas meets the requirements described in Use in hazardous
areas (Page 17).
Power up the device. Devices with local display show a screen for initial startup (Page 85).
6.3 Local commissioning via HMI
6.3.1

Local display

The device is commissioned/operated with the touch keypad on the local display.
The elements are actuated by touching the glass panel on the appropriate key. Pressing harder
will not activate the key, but using a thumb instead of a finger tip will help. The text display above
the operating elements gives a menu-guided operation of the individual device function/
parameters. Successful operation of the key is confirmed by a small green LED at the right of
the display.
①
②
③
Figure 6-1
Note
Calibration of the keypad
When the lid is closed, all keys are calibrated (< 5 seconds). During calibration the LED is on
and the keys cannot be operated.
If one of the keys is pressed for more than 10 seconds, the calibration of this key begins which
has a duration of less than 10 seconds. Release the key for further operation.
84
Full graphical display
LED (for indication of key operation)
Touch keypad
Local display
Operating Instructions, 01/2019, A5E44030648-AB
SITRANS FC330