Connecting; General Safety Requirements - Siemens SITRANS MAG 1100 Operating Instructions Manual

Connecting

Before connecting
5.1

General safety requirements

www.eltra-trade.com
The following contains a short description of how to connect a remote mounted sensor to
transmitter types:
● SITRANS F M MAG 5000 / 6000 (standard versions)
● SITRANS F M MAG 6000 19" with Safety barrier
● SITRANS F M MAG 6000 I Ex de
For more information, for example about wiring of power supply and outputs, refer to the
operating instructions for the respective transmitters.
● Check that the serial numbers on the sensor and the SENSORPROM
WARNING
The pertinent regulations must be observed for electrical installation.
● Never install the device with the mains voltage switched on!
● Danger of electric shock!
● The electrodes and magnetic current line may only be connected when the device is not
connected to the power supply.
● If the housing is under voltage (power supply), the cover may be unscrewed by qualified
personnel only.
WARNING
Mains supply from building installation Class II
A switch or circuit breaker (max. 15 A) must be installed in close proximity to the equipment
and within easy reach of the operator. It must be marked as the disconnecting device for the
equipment.
Note
Hazardous area applications
Special requirements apply to the location and interconnection of sensor and transmitter. See
Installation in hazardous area (Page 11).
info@eltra-trade.com
5
unit are identical.
®
33
+421 552 601 099