Table of Contents
Advertisement
1.6 Programmer Specifications
The table below details the hardware specifications for the programmer. Please refer to the stated
section for further information about any specific parameter.
#
Parameter
1
Target Device
Support
2
Target Device
Programming
Interfaces
3
Operating modes
4
On-board FLASH
Memory Store
5
Project storage in
Memory Store
6
Keypad entry
7
Status LED's
8
Programmer Display 2 x 16 Back-lit LCD
9
Target Vcc
Voltage Detection
LED
10
Description / comment
See Device Support List
The programmer supports the following programming
interfaces:
•
Atmel Low Voltage SPI
•
Atmel High Voltage SPI (+12V Vpp)
•
Atmel AVR JTAG (chargeable update)
•
Atmel (formerly Temic) 8051 Boot loader ISP
•
Philips (NXP) 8051 - Boot Loader ISP
•
Generic I2C (SDA + SCL)
The programmer supports the following operating modes:
•
Development Mode (PC controlled)
•
Project Upload Mode (PC controlled)
•
Standalone Mode - Keypad + LCD operation
•
Standalone Mode – Automatic Target Connect /
Disconnect Sensing
•
Standalone Mode - Remote Controlled via 'ASCII Text
Communications' RS-232 Serial Protocol
•
Standalone Mode - Remote Controlled via 4-wire TTL
Remote Control Port
•
PC controlled via ISP-PRO software (chargeable
upgrade)
•
PC controlled via ConsoleEDS utility (chargeable
upgrade)
32 Mbits (4 MBytes) FLASH Memory
64 x Programming Projects
4 x Push Button - <YES>, <NO>, <UP>, <Down>
i.
3 x Status LED's located on the programmer:
<PASS>, <BUSY>, <FAIL>
ii.
3 x remote Status LED's can also be connected off-
board on a Test Fixture via the 'Remote System
Status' port.
This LED is located on the I/O-CON Module:
•
Target Vcc (POWER) LED will light when Target Vcc is
detected.
•
Threshold detection voltage: approx 3.1V
PPM3 MKII Programmer - User Guide - V1.04 - 10
Refer
to
section
1.7.1
1.7.2
2.4
th
May 2008
Advertisement
Table of Contents
