Table of Contents
Advertisement
7 - Menu 3, Calibration
Menu 3.3 Boom
Menu 3.3.1 Width
Use the navigation keys to enter boom width.
Press
to confirm.
Menu 3.3.2 Number of sections
Use the navigation keys to set number of boom sections.
Press
to confirm.
Menu 3.3.3 Nozzles/section
Use navigation keys to set correct number of nozzles per section.
Press
to continue to next boom section.
Press
after the last section.
Menu 3.3.4 End nozzles
If end nozzles are fitted, set the value to the equivalent coverage by the
boom nozzles.
Example
End nozzle coverage is 2 metres. This is equal to 4 boom nozzles.
The value is then adjusted to 04.
μ
ATTENTION! It is important that the volume applied from the end nozzle matches the volume applied under the
boom. This is a comparison of volume per minute per length (litre/min/meter).
When the end nozzle is active, the area covered and volume sprayed is calculated and registered. If "Active boom size"
is displayed, it will show an increase, when the end nozzle is activated.
48
3.3.1
WIDTH
3.3.2
NO. OF SECTIONS
sections
3.3.3
NOZZLES/SECTION
Section YY
3.3.4
END NOZZLES
Boom nozzles
00.0 m
XX
XX
XX
Advertisement
Table of Contents
