Menu 3.3 Boom; Menu 3.3.1 Width; Menu 3.3.2 Number Of Sections; Menu 3.3.3 Nozzles/Section - Hardi HC6500 Instruction Book

Sprayers

Hide thumbs Also See for HC6500:

Table of Contents

7 - Menu 3 Calibration

Menu 3.3 Boom

Use the ¿ or ª keys or numeric keys to enter boom width.

Press # to confirm.

Use the ¿ or ª keys or numeric keys to set number of boom sections.

Press # to confirm.

Use ¿ or ª keys or numeric keys to set correct number of nozzles per section.

Press # to continue to next boom section.

Press # after the last section.

If end nozzles or Bijet are fitted, it should be set up corresponding to the number of boom nozzles it covers.

1. In menu [3.3 Boom setup] go to the menu [3.3.4 End nozzles and Bi-jet].

2. Press #.

3. Select submenu corresponding to the type of end nozzle:

Menu 3.3.4.1 None

Menu 3.3.4.2 End nozzles fitted

Menu 3.3.4.3 Bi-jet fitted

4. Press #.

5. In the sub menus [3.3.4.2] and [3.3.4.3] set the value to the equivalent coverage by the boom nozzles. E.g. end nozzle

coverage is 5 feet. This is equal to 3 boom nozzles.

ATTENTION! It is important that the volume applied from the end nozzle matches the volume applied under the

boom. This is a comparison of volume per minute per length. (Gallon/min/foot).

When the end nozzle is active, the area covered and volume sprayed is calculated and registered. If "Active boom

size" is displayed, it will show an increase when the end nozzle is activated.

7.6

Table of Contents

Show Quick Links

Table of Contents