Kp8F - Configure Shared Device - Siemens SIMATIC KP8 Operating Instructions Manual

Setting the KP8 and KP8F
6.7 KP8F – Configure Shared Device
Set the DIP switch on the back of the KP8F as follows:
The illustrated switch settings correspond with the binary address 383.
Result
The HMI device can be uniquely identified by the configured PROFIsafe target address.
6.7 KP8F – Configure Shared Device
KP8F is designed for shared device.
Shared Device is the parallel and independent access from two different controllers to the
same HMI device. A fixed assignment of the different modules that are used in an
automation device must be configured to a select controller. The unique assignment of the
module to the controller is always guaranteed and visible for the user.
Requirement
● A shared device is created in the project.
● The Shared Device is now inserted in the PROFINET IO system.
● "HW Config" is open in the SIMATIC Manager.
68
Information on the configuration of Shared Device can be found in the online help
"STEP 7 Version 5.5".
Coupling with the controllers of the station is carried out automatically.
Operating Instructions, 10/2010, A5E03284305-01
KP8, KP8F