Siemens SIMATIC KP8 Operating Instructions Manual page 66

Setting the KP8 and KP8F
6.5 Setting KP8F - STEP 7
6. In the list, select:
Note
Make sure that the sensor is monitored corresponding with its connection.
7. Click "OK".
8. Open the "PROFIsafe" tab.
9. Enter the password that was assigned when the safety program was created in
10. Click "OK".
11. If necessary, change the "F_Dest_Add" parameter.
12. Change the monitoring time "F_WD_Time" if needed.
13. Click "OK".
Result
The HMI device will now respond in operation according to the new setting. The switch
states of the digital inputs of the HMI device are stored in the specified address area of the
controller.
66
– Not activated
"Not activated" is the default entry.
– 1oo2 (2v2)-evaluation, EMERGENCY STOP
– 1oo1 (1v1)-evaluation, single-channel
The selection is based on the connection corresponding with chapter "Connect KP8F -
fail-safe inputs (Page 46)".
The entries are saved. The dialog box closes.
If no access rights exist, the following dialog box will be shown.
Distributed Safety.
The dialog box closes.
To do this, use the "Change value" button. Assign a network and station-wide unique
address.
The entries are saved. The dialog box closes.
Operating Instructions, 10/2010, A5E03284305-01
KP8, KP8F