Connecting The Power Supply - Siemens SIMATIC KP8 Operating Instructions Manual

Mount and connect KP8 and KP8F
4.4 Connecting the HMI device
4.4.3

Connecting the power supply

Configuration diagram
The figure below illustrates the connection between the power supply and the HMI device.
Connecting the connector
The plug-in connector for connecting the power supply is contained in the accessory kit and
is designed for cables with a maximum cross-section of 1 mm
when stripping the wire.
If you are using a stranded lead, use wire-end ferrules.
NOTICE
Damage possible
Do not connect the lines if the connector is in the HMI device. You may otherwise damage
the mounting of the HMI device socket.
Always remove the connector to connect the wires.
To open the connectors, press in the opening provided with a screwdriver for slotted screws.
Slide the cable into the connector enclosure and remove the screwdriver. The wire is fixed.
44
. Note the following diagram
2
Operating Instructions, 10/2010, A5E03284305-01
KP8, KP8F